Submersible mixer selection and installation notes

Submersible mixers enhance the mixing function and prevent sludge from settling. Its special installation system allows quick installation and removal of submersible mixers without the need to drain wastewater from the tank. Here we will analyze in detail the selection of submersible mixers, installation precautions, submersible mixer installation steps.

First, the selection of matters needing attention

In order to ensure that the submersible mixer achieves the best operating results, please use the following information provided by the user;

â—Ž purpose of use;

â—Ž pool type and size, including water depth;

â—Ž characteristics of stirring media, including viscosity, density, temperature, and solids content.

Second, installation precautions

â—Ž guide rod or guide wire should be horizontal and vertical, can be used plumb correction;

◎When lifting the submersible mixer, the hook should rise 5°-10° on the horizontal plane

â—Ž Through the adjustment of the chain on the lifting device, the submersible mixer slides down along the guide bar or the guiding wire, and the lifting center of the lifting hook and the submersible mixer are on the same vertical line.

Third, the submersible mixer installation steps

1. During installation, firstly determine the position of the submersible agitator according to the floor plan, find the top and bottom embedded parts according to the position, and check whether the error of the geometric size, position and flatness of the embedded part is within the scope of the specification permission;

2. Determine the position of the bolt holes on the upper support, lower support, and lifting frame supports by drilling. Drill holes using electric drills. The upper support and lifting frame base are fixed with M16*280, and the lower support is fixed with M16*150 chemical bolts.

3, install submersible mixer guide rods, fastening bolts;

4, install the upper lifting frame;

5. The submersible agitator host uses the lifting frame to descend along the upper guide rod, so that the elevation of the axis position of the submersible agitator is the same as the design elevation of the drawings of the design institute. Fixed lifting rope. The submersible agitator mainframe is supported by a support frame on the guide rod.