As a dangerous goods vehicle, Chusheng tank trucks should have a complete set of operating rules to prevent dangerous situations. In the event of a dangerous situation, it should also be handled in accordance with the operating rules, and only in this way can the loss be reduced to a minimum. What operating practices are required for Chusheng tank trucks , and the following content is a reference for everyone.
When storing the vehicle, the vehicle should be parked in a special carport, and the carport should be far away from the fire source, set a clear fire-fighting sign, be equipped with fire-fighting equipment, and the fire-extinguishing equipment should be checked whether it is within the warranty period. When the tanker is driving, it must be strictly within the safe speed, avoid other vehicles, choose a good driving route, and stay away from the open flame. Lightning lightning weather should pay attention to lightning protection and high-voltage lines. It is strictly forbidden to drive during the driving process, open the gas tanker, etc. to avoid dangerous situations. All electrical devices in the vehicle must have good insulation. Vehicle work lighting should be a safety light of 36V or less. Â
In particular seasons should pay attention to the details, summer should pay attention to sun protection, more than a certain temperature is prohibited to travel outside, to regularly check the safety valve and high pressure valve. In winter, when the oil pipeline is frozen, it is strictly forbidden to bake with an open flame and to freeze it with a barbecue. Dongfeng 5-6 tons of refueling trucks must implement special personnel management measures, without permission, can not use the tanker refueling vehicles, violations shall be investigated. In the process of inspection and repair, if the operator needs to enter the oil tank to carry out operations, it is strictly prohibited to carry the fire, and there must be reliable safety protection measures. There must be professionals outside the tank to monitor.
Chu Sheng tanker tank oil hole should be tightly sealed, drain valve, drain pipe should be no leakage, the tank vent should be open, the oil pump inlet filter should be frequently cleaned, send oil hose should be installed immediately after use The joint cover on both ends shall not allow dirt to enter. After the completion of refueling and unloading, it is necessary to check carefully whether there are oil leakage or oil dripping in each valve and interface. After the Chusheng tanker is used, it is necessary to ensure that the vehicle and the parking position are safe before leaving.
In-mould labelling (IML) was initially designed for blow molding, though developments using injection molding or thermoforming with reel-fed systems have increased the efficiency of the labelling process. The original concept involves coating the reverse side of the label with a heat seal layer, followed by a substrate material in which heat resistant ink is applied to. A heat resistant coating of lacquer is then applied .In-mould labelling is a popular method of decorating injection molded parts for consumer electronics and for plastic bottles. Notebook computer and cellphone manufacturers are adopting IML technology for greater wear resistance than spray painting or pad-printing. IML can provide greater decorating options than other methods. Multi-color screen printed and offset lithography printed graphics are used to produce products with higher quality graphics than available with other decorating methods. What is IML?The term "in mould labelling" is directly derived from the technique: a preprinted polypropylene (PP) label is placed in a mould. This mould has the shape of the end product, e.g. the shape of a butter tub.Then the molten PP is added to the mould. It fuses with the label, and while curing, takes the shape of the mould. Result: label and packaging become one.In mould labelling can be done in the following production processes:
Injection moulding Blow moulding Thermoforming In mould labelling offers several major advantages: Maximum print quality,Strong and hygienic, Shorter production time and lower production costs, Environmentally-friendly,Wide range of look & feel options,Quick design changeovers.
Imd Moulding Parts,Iml Container Cover,Waterproof Household Cover Iml Mould,Mould In Labeling Top Bottom Cover
Topwell Spring Development Ltd. , http://www.topwelldesign.com