What if the engine does not start?

â˜… What if the engine does not start? â˜…

First of all, check to see if the spark plug is damaged. If damaged, just replace the new spark plug. In general, the spark plug of a car uses about 20,000 to 30,000 kilometers.

Check if the battery voltage is sufficient. Many batteries have been designed with observation holes for detection. When they appear green, they can be used normally, appear black, need to be replenished or maintained, and appear white. The battery should be replaced.

If you forget to turn off the lights while parking, you may run out of power. If this is the case, turn the ignition switch ON, put the car on the second gear, step on the clutch, and drag the car. When driving to a certain speed, release the clutch and the car will start naturally. This approach is applicable to failures that are just insufficient power. If there is a problem with the ignition system, this method will not only fail to work, it may also have a bad effect on the catalytic converter, and other vehicles can damage the timing belt and cause serious problems. Mechanical failure. Vehicles equipped with automatic transmissions cannot be started by the cart, and a jumper cable can be used to connect the battery of another vehicle to start the engine.

Metal Anodizing

Anodizing is an electrochemical finishing process that results in a durable and corrosion-resistant protective finish. In particular, aluminum is well-suited for anodizing treatments.

In contrast to other finishing processes that apply the coating or finish to the substrate, the anodizing process leverages the aluminum oxide layers that naturally occur in aluminum and increases them in thickness to form a fully integrated surface finish. Depending on the specifications of the anodizing project, the oxide layers can be thickened minimally or to more than 100 times their original thickness.

Advantages of Anodizing

1.Improved corrosion and wear resistance

2.Good aesthetic

3.Can achieve a variety of colors

4. Clear finish options are also available

5.Lower cost compared to Powder Coating

6.Extremely durable,hard,abrasion-resistant,and long-lasting.

7.Recyclable

Stainless steel, aluminum, titanium alloy ,sheet metal, brass, copper etc can be done by anodizing with different colors, we have many parts that ever did, so please let us know what you are looking for , we can do the CNC Machining for the part manufacture and 2nd process anodizing surface treatment.

Metal Anodizing,Anodized Aluminum Sheet,Metal Aluminum Anodized,Anodizing Aluminum

Suzhou FCE precision electronics Co., LTD , https://www.sjfukeyifcesz.com